Parts Identification
Discontinued Units: Which Parts Can Still Be Sourced
Which parts can still be sourced for a discontinued Sub-Zero is settled one part at a time, against the model and serial, once the diagnosis has named what failed. No list is promised in advance. Sub-Zero Repair Redmond, (425) 905-2822, starts from the tag reading and quotes the repair after the diagnosis.
-
Read the model and serial
Copy both numbers off the tag, up by the hinge on the door frame. Sub-Zero asks for them whenever the factory or a parts distributor is contacted, and every search that follows starts from them.
-
Diagnose before sourcing
A part is worth hunting for only once testing shows it has failed. Ordering on a guess spends the search, and the waiting, on the wrong component.
-
List what the diagnosis names
Write down each failed part and note which group it belongs to: the sealed system, or the rest of the unit.
-
Source each part against the tag
Each part is checked for the exact model and serial. A 600 Series built before serial 1810000 and a later one with the same model number carry different controls, so the model alone is not enough.
-
Judge the sealed system on its own
If the compressor, condenser, evaporator or the refrigerant tubing is involved, that side is assessed separately before money goes into anything else.
-
Decide, then order the cabinets
Only when every named part has an answer is the unit kept or retired, and only then is new cabinetry committed around it.
Why there is no parts list on this page
Availability for discontinued units changes, and a list printed today would be wrong for someone reading it later. A part that one serial range takes may not fit another carrying the same model number. So the only honest answer is the one given per job: this part, for this model and serial, can or cannot be had.
How Sub-Zero splits a unit
Sub-Zero’s own service literature divides a refrigerator into two groups. The sealed system is the compressors, condensers, evaporators, filter-driers, heat exchangers and every tube that carries refrigerant. Everything else, from the control components, fans and defrost heaters to the water valves, ice makers, hinges and door closers, sits outside it. Sub-Zero is explicit that condenser fan motors and compressor electricals are not sealed-system parts, even though they sit next to the compressor.
That split is how a restoration is planned. Parts outside the sealed system are ordinary repairs. Work inside it is a bigger decision, and it always includes a new filter-drier.
Restoration as a repair
On this site restoration means bringing an old built-in back to working order, not refinishing it. The unit is diagnosed, each failed part is sourced or ruled out, the sealed system is judged, and the work is quoted after that diagnosis. Nothing is promised about a part before its search has been run against the tag.
- Sealed system
- Compressors, condensers, evaporators, filter-driers, refrigerant tubing
- Rest of the unit
- Controls, fans, heaters, water valves, hinges, closers, ice makers
- Not sealed system
- Condenser fan motors, compressor electricals
- Search key
- Model and serial from the tag
- Visit
- $89, credited to the repair
Asked on the phone
- What does restoration mean on an old Sub-Zero?
- Here it means repair, not cosmetics: worn parts outside the sealed system are replaced, and the sealed system is tested and judged on its own. Whenever that system is serviced, Sub-Zero's manual requires a new filter-drier. Sub-Zero Repair Redmond, (425) 905-2822, quotes after the diagnosis.
Discontinued parts that needs a technician?
Sub-Zero Repair Redmond · $89 service call, deducted once the repair goes ahead · on site 0800 to 2000 hrs, all seven days
- Checked by
- Dean Halvorsen
- Bench
- sealed systems and airflow
- Trade
- 19 yrs
- Card
- EPA 608 certified
- Revised
